![]() Now close everything and enter the copied arduino file go to tools / boards and u should get Atmega 328 on a breadboard(8 HZ internal clock),select it than scroll down to programmer(in tools also) and select arduino as isp.sellect the correct comm port. Now one last thing ,go back once enter tools /avr/etc replace that avrdude file with the one i attached. Ok now enter the copied arduino file go to examples than arduino ull c a file called boards, just delete it and replace it with the one attached in this step. Make a copy of the arduino software not the IDLE but the intire file uve installed so that the changes won effect the origonal copy. Now before plugging the wires back u have to make some changes to some specific files. In my case its arduino uno and press upload after uploading remove the usb cable of the arduino. To upload the code just open the Arduino IDLE which is the place where u type codes.Ĭlick on files/examples/Arduino ISP and another screen pops up make sure u have the correct board selected (not the atmega microcontroller on the breadboard). Now just unplug the +5v and gnd jumper wires before u upload the Arduino isp code. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |